i. All papers and a covering/submission letter should be submitted electronically.
ii. The manuscript should be in an editable format.
iii. Submission of a paper implies that it has not been published previously (except in the form of abstract, lecture or thesis), it has been approved by all the authors, is not simultaneously under consideration for publication elsewhere and the paper does not contain anything unlawful or defamatory or anything that would constitute a breach of contract or copyright issues.
iv. All editorial correspondence should be addressed to the Chief Editor
2. Manuscript Preparation
i. Manuscripts should be double spaced and with margins of at least 2.5 cm on the top and left-hand side of the papers.
ii. Ensure the manuscript has page numbers in the middle at the bottom and add (enable) continuous Line Numbering in the text of the paper.
iii. Use font Times New Roman 12 points.
iv. Limit your manuscripts to a maximum of 25 pages of A4 size including illustrations (e.g., photographs, diagrams, tables). The maximum length for short communications will be 15 pages. OR: The paper should not contain more than 8000 words, and not more than 10 figures and 6 tables.
v. Language: Write your text in good English (British English)
vi. The manuscript must be spell-checked and grammar-checked before submission.
Regardless of the application used, when your electronic artwork is finalized, please 'save as' or convert the images to one of the following formats (note the resolution requirements for line drawings, halftones, and line/halftone combinations given below):
EPS (or PDF): Vector drawings. Embed the font or save the text as 'graphics'.
TIFF (or JPG): Colour or grayscale photographs (halftones): always use a minimum of 300 dpi.
TIFF (or JPG): Bitmapped line drawings: use a minimum of 1000 dpi.
TIFF (or JPG): Combinations bitmapped line/half-tone (colour or grayscale): a minimum of 500 dpi is required.
viii. Colour artwork: Please make sure that artwork files are in an acceptable format (TIFF, EPS or MS Office files) and with the correct resolution. If, together with your accepted article, you submit usable colour figures then JWEMPO will ensure, at no additional charge that these figures will appear in colour on the Web regardless of whether or not these illustrations are reproduced in colour in the printed version. Please indicate your preference for colour in print or on the Web only.
Please note: Because of technical complications which can arise by converting colour figures to "gray scale" (for the printed version should you not opt for colour in print) please submit in addition usable black and white versions of all the colour illustrations.
4. Figures and Tables
i. Figures and tables should appear in numerical order and must be described/cited in the body of the text.
ii. Originals of all figures should be in black ink and all lettering must be readable and big enough to allow reduction for final layout.
iii. Tables should have no visible internal vertical or horizontal lines.
iv. Please ensure the figures and the tables included in the single file are placed next to the relevant text in the manuscript, rather than at the bottom or the top of the file. The corresponding caption should be placed directly below the figure or above the table.
Follow internationally accepted rules and conventions: use the international system of units (SI). If other quantities are mentioned, give their equivalent in SI.
Always leave a space between number and unit (e.g. 6.4 mg/L, 25 °C, 20 g), however no space before the “%” and "/"signs. Use the international systems and rules for writing the scientific names for various substances such as chemicals.
Define abbreviations that are not standard in the field at their first mention. Ensure consistency of abbreviations throughout the article if applicable.
Please submit math equations as editable text and not as images. Present simple formulae in line with normal text where possible and use the solidus (/) instead of a horizontal line for small fractional terms, e.g., X/Y. In principle, variables are to be presented in italics. Powers of e are often more conveniently denoted by exp. Number consecutively any equations that have to be displayed separately from the text (if referred to explicitly in the text).
6. Manuscript Structure
Subdivision - numbered sections
Divide your article into clearly defined and numbered sections. Subsections should be numbered 1.1 (then 1.1.1, 1.1.2 ...), 1.2, etc. (the abstract is not included in section numbering). Use this numbering also for internal cross-referencing: do not just refer to "the text". Any subsection may be given a brief heading. Each heading should appear on its own separate line.
Manuscripts should contain the following parts:
6.1 Title page information
Title: The title must be short and precise. Abbreviations should not be used, except if necessary. The title of the paper should be in bold title case (capitalize all major words) with font size larger than the text (2 points greater than the font size of the text).
Author information: The title will be followed by the author(s)’ name(s), institutional affiliations(s), postal and e-mail addresses. Indicate the affiliations with a superscript number immediately after the author's name and in front of the respective address.
Clearly indicate the corresponding author and provide telephone number(s). The names of author(s) should be in the following order: First name Initials Surname. Example: Victoria, J.M. Serikali.
This should be a brief summary of what was done, the main findings and the conclusions drawn. The abstract should not exceed 200 words. All papers, including short communications must have abstracts.
The abstract should not be italicized, except for scientific names and other items that are necessarily required to be italicized.
For research articles you are supposed to prepare a structured abstract, a template of which can be viewed through this link [Click here]
Keywords: Authors must provide 4 to 6 keywords below the abstract.
This should contain a brief survey of the relevant literature and the objectives of the work. It should also state knowledge gaps that were filled. Provide background information to support the motivation for the study, and state the study objectives or hypotheses.
6.4 Materials and Methods
Sufficient information should be given, including relevant references, so that the study can be repeated by someone else.
Provide clear and concise descriptions of all findings. Present all results on which study conclusions or inferences are based (in whole or in part). Report the results in the main text and in tables or figures as appropriate. All illustrations must bear full captions, and must be specifically mentioned in the text, e.g., “Potassium ions enhanced stomata opening (Figure 5)”. The same data should not be presented both in the form of a graph and a table. Short tables or graphs should be combined to save space.
This should emphasize the significance of the results and their relationship with other published work, and with the original objectives of the investigation. A brief concluding statement and recommendations for further work are normally given in the final paragraph. The section on results and that on discussion may be combined to give one section on “Results and Discussion.” The "Results and Discussion” section can be organized in appropriate subheadings.
The main conclusions of the study should be presented in a summary format.
If there is more than one appendix, they should be identified as A, B, etc. Formulae and equations in appendices should be given separate numbering: Eq. (A.1), Eq. (A.2), etc.; in a subsequent appendix, Eq. (B.1) and so on. Similarly, for tables and figures: Table A.1; Fig. A.1, etc.
This should be very brief, about one to two sentences in a separate section at the end of the article before the references and do not include them on the title page, as a footnote to the title or otherwise. List here those individuals who provided help during the research (e.g., providing language help, writing assistance or proof reading the article, etc.).
Formatting of funding sources
List funding sources in a standard way to facilitate compliance to any funder's requirements: e.g
Funding: This work was supported by a grant from The Ministry of Water [grant numbers xxxx, yyyy]; the Bill & Melinda Gates Foundation, Seattle, WA [grant number zzzz]; and the United States Institutes of Peace [grant number aaaa].
If no funding has been provided for the research, please include the following sentence:
This research did not receive any specific grant from funding agencies in the public, commercial, or not-for-profit sectors.
7.1 Citation in text
Single author: Use surname of author and year of publication, e.g., John (2017) or (John, 2017).
Two authors: Surnames and year, e.g., Peter and Suleiman, 2012.
Three or more authors: First author's surname followed by the abbreviation “et al.” and the year of publication should be used in the text (but not in the list of references), for example: Maharage et al. (2018) or (Maharage, et al., 2018).
Different references cited together should be in date order, for example: (Mark, 1999; Peter and Suleiman, 2012; Green, 2014). If a paper has been accepted for publication but has not been published the term “(in press)” should be used instead of a date.
7.2 List of references
References should be listed alphabetically at the end of the paper. Only the literature actually cited in the text should be included here. The names of periodicals (e.g., journals or magazines) should be in title case and italicized. Use correct standard abbreviations for the titles of the journals.
References by the same author(s) should be arranged chronologically. References by the same author(s) published in the same year should be cited using a, b, c, etc., after the year of publication in the text and list.
7.3. Journals reference style (APA)
In the case of journals, authors’ names followed by initials, the year of publication, the title of the article, the name of the journal, the volume and the first and last pages of the article should be given in that order. For example:
Hecky RE, Mugidde R, Twongo T, Balirwa J and Mavuti K 2000 Ecosystem change in Lake Victoria. Tanz. J. Sci. 28: 50-61.
La Vignera S, Condorelli RA, Vicari E, D'Agata R and Calogero AE 2012 Effects of the exposure to mobile phones on male reproduction: a review of the literature. J. Androl. 33(3): 350-356.
Fisher, T.R., Peele, E.R., Ammerman, J.W. & Harding, L.W. 1992: Nutrient limitation of phytoplankton in Chesapeake Bay. Mar. Ecol. Prog. Ser. 82: 51–63.
7.4. The books reference styles
(a) Standard book:
Names and initials of all authors, year. Title of the book. Publisher, location of publisher, total number of pages.
Fennel, W. and Neumann, T., 2004. Introduction to the Modelling of Marine Ecosystems. Elsevier, Amsterdam, 297 pp.
(b) Article in a book:
Names and initials of all authors, year. Title of paper. Names and initials of the volume editors, title of the edited volume. Publisher, location of publisher, first and last page numbers of the paper.
Thomas, E., 1992. Middle Eocene-late Oligocene bathyal benthic foraminifera (Weddell Sea): faunal changes and implications for ocean circulation. In: Prothero, D.R., Berggren, W.A. (Eds.), Eocene Oligocene Climatic and Biotic Evolution. Princeton Univ. Press, Princeton, NJ, pp. 245-271.
Boyton WV 1984 Cosmochemistry of the rare earth elements: meteorite studies. In: Henderson P (ed) Developments in Geochemistry vol. 2, Elsevier, Amsterdam, pp. 63-114.
Use of unpublished theses and reports is strongly discouraged. If they are essential and the editors agree, you must supply:
Names and initials of all authors, year. Title of item. All other relevant information needed to identify the item (e.g., technical report, Ph.D. thesis, institute, current status i.e. in press/unpublished etc.).
Moustakas, N., 1990. Relationships of Morphological and Physiochemical Properties of Vertisols under Greek Climate Conditions. Ph.D. Thesis, Agricultural Univ. Athens, Greece, unpublished.
Magufuli JPJ 2009 The potential of anacardic acid self-assembled monolayers from cashew nut shell liquid as corrosion protection coatings. PhD thesis, University of Dar es Salaam.
Conference proceedings papers:
Names and initials of all authors, year. Title of paper. Name of the conference. Publisher, location of publisher, first and last page numbers of the paper.
Smith, M.W., 1988. The significance of climatic change for the permafrost environment. Final Proceedings International Conference on Permafrost. Tapir, Trondheim, Norway, pp. 18-23.
(d) Web references
As a minimum, the full URL should be given and the date when the reference was last accessed. Any further information, if known (DOI, author names, dates, reference to a source publication, etc.), should also be given. Web references should be included in the reference list.
Indicate the section headings in the article as follows:
First-level headings (e.g., Abstract, Introduction, Materials and Methods, Results and Discussion, Conclusion, Acknowledgements and References) should be in bold title case.
Second-level headings should be in bold sentence case.
7.6. Ethical Guidelines
JWEMPO will acquire membership of the global Committee on Publication Ethics (COPE) as an individual journal membership and adhere to its guidelines as well as ensure the ethical quality of the publications and the respective authors. COPE Guidelines are attached in Annex No. 3.
Ethical standards for publication will be observed to ensure high-quality scientific publications, public trust in scientific findings, respect for human and animal rights, intellectual and property rights and that people receive credit for their ideas.
Studies on human or animal subjects must provide statements clearly showing that the responsible Ethical Committee(s) approved the experiments and which should be in accordance with the international standards, e.g., Declaration of Helsinki (1964).
Authors must avoid unethical conducts such as data fabrication and falsification, plagiarism, multiple submissions, redundant publications, etc.
Editors and reviewers shall treat the articles they handle with maximum confidentiality and shall not use knowledge of the work before its publication to advance their own interests. Reviewers will remain anonymous. As well, reviewers/editors shouldn’t display favouritism of own work through recommendation of own citations as guarantee for paper acceptance.
Policies will be put in place for addressing such issues related to allegations of misconduct, complaints and appeals, conflicts of interest and competing interests, authorship and contributorship, data and reproducibility, ethical oversight, intellectual property, journal management, peer review processes, post publication discussions and corrections.
8. Plagiarism Management
Anti-plagiarism software TURNITIN will be utilized to ensure quality and originality of submitted articles. Plagiarism check will be performed in a two-point location by the Managing editor and Associate editors.
Note: Plagiarism should not be above 30%.
9. Declaration of Interest
Authors should declare the potential competing or conflicting interest(s) regarding publication of the work (if any).
9.1 Peer Review
This journal operates a blind peer review process. Authors are required to provide full contact details (including institutions, e-mail addresses and telephone numbers) of four to six potential reviewers. At least two of the suggested reviewers should not be from the same institution as the author. Each manuscript will be initially evaluated by the Chief Editor and an Associate editor for checking suitability of the content for the journal. The manuscript deemed suitable will then be sent to at least three expert reviewers to assess the quality of the paper.
During submission of the revised manuscripts, the changes or corrections should be clearly indicated and a cover letter or matrix must clearly provide the author(s)’ responses to the reviewers’ comments. The Chief Editor is responsible for the final decision concerning acceptance or rejection of papers.
For the manuscripts recommended for publication, the author(s) will be expected to sign the JWEMPO copyright assignment form. Where necessary the author(s) will need to obtain permission to publish material protected by copyrights and provide evidence to the journal to that effect.
Provision will be made in the form for work performed for the United Republic of Tanzania Government (for which Copyright cannot be assigned) and other similar extenuating circumstances. Copyright notes from solicited publisher will also be included in the form.